The stamping machine rose again, and the robotic arm turned the flattened alloy to stand the elongated side upright.
The stamping machine continued to descend, pressing the glowing, elongated alloy back into a square shape.
The alloy became longer than before and appeared much smaller compared to the section behind it.
The robotic arm extended the unprocessed alloy forward a bit, placing it under the stamping machine, repeating the method.
In the blink of an eye, the alloy was elongated.
It was sent into the next stamping equipment.
This time, it faced pressure from all sides instead of just up and down.
After stamping, the alloy turned into a glowing yet slightly rough alloy rod.
The glowing alloy rod was sent forward, rolling into a long groove.
Metal molds at both ends of the groove, after debugging, gathered the solid alloy rod, controlling it in the center.
