The spindle must spin very fast in order to complete the spinning action.
A steering wheel at the end of the spindle helps, but it's not convenient enough.
Up until now, manual spinning has always been the better method.
It's simple and easy to learn.
But the efficiency is too low.
The spun thread is also too thick.
And the spinning wheel is too difficult to make.
His problem is a lack of hands-on ability, which makes creating a spinning wheel feel so exhausting.
Want to use a gear to drive the spindle to rotate rapidly. This requires some technical skills.
Without metal tools, it's just difficult.
But he can forcibly proceed to make it.
A thick wooden stake, planted in the ground, about one point two meters high.
Two holes dug above it, one on top, one halfway down.
A spindle is stuffed into the top hole. It's used for spinning and winding thread.
Another spindle stuffed into the lower hole, connected to a gear.
How is the gear made?
